|
PRICE SHOWN IS FOR ONE (1) ROLL, ONE (1) INCH WIDE X 36 YARDS. WE CAN FURNISH ANY REASONABLE WIDTH FROM 1/16†TO 36†IN 1/16†INCREMENTS. PLEASE CONTACT US WITH YOUR ROLL WIDTH REQUIREMENTS AND WE WILL QUICKLY LIST THE ROLL WIDTHS YOU WISH TO PURCHASE. ATS 258 Polyimide tape is an economical solution for protecting printed circuit board connector fingers during wave soldering and hot air leveling. It is also used for high temperature holding and conformal coat masking, leaving no residue upon removal. ATS 258 Polyimide tape offsets Saint Gobain K250, 3M 5419, and Permacel P-221. -100º F to +500º F (-73º C to +260º C) * CERTS AND TEST REPORTS CAN BE PROVIDED WITH YOUR ORDER AT NO CHARGE IN MOST CASES. * Price shown is in US dollars * Be sure to indicate the quantity of rolls you need of this width. * Although we only have a few width increments shown, we can accommodate your width requirement by sending us an email. When we receive your information, we will quickly list the roll width you wish to purchase. * Any width is available from 1/16 inch to 36 inch and cut to size from our stock. * Roll width accuracy is +/- 0.015 inches. * Minimal fractional (less than 1 inch) pricing is 1/4 inch per roll. * Minimum total order charge is 1 inch of width. * We reserve the right to refuse order requests that we deem to be beyond our scope of capabilities. This product is custom-cut to the required size with each order and therefore cannot be returned unless there is a specific problem with the manufacture of the product itself. If this is the case, please contact us for additional assistance and we will do our best to rectify your problem. THE PHOTO SHOWN IS ONLY A GENERIC PHOTO AND NOT TO BE CONSTRUED TO BE THE ACTUAL PRODUCT BEING SOLD. THANK YOU FOR STOPPING AND SHOPPING!!! (We do not proofread any ads submitted by members) |
BillyWhitfield@desmoines-classifieds.com (Billy Whitfield) for more information. Your emails will be instantly forwarded to the poster's private address.
