Fowler Cuttermaster tool cutter grinder mill milling radius attachment ( see all Pictures ) these units go for around 2K without radius Description mfg info on a new item for reference only!!! CUTTERMASTER TOOL AND CUTTER GRINDER - The Original CUTTERMASTER TOOL AND CUTTER GRINDER - The Original * Grinds O.D.s and ends of standard end mills in one setup within just a few minutes. * Extremely versatile and is used for much more than just end mills. With the z-axis you get 8 different axes to work with for unlimited versatility. * The pneumatic finger instantly and automatically sets primary and secondary clearance angles with the flip of switch. * Air bearing has a 360 degree swivel base for taper grinding. * The Jet-Stream air bearing fixture is precision honed and capable of grinding to close tolerances. The spindle sleeve is made from stainless steel and the spindle itself is hard chromed steel. * Takes standard 5C collets, with end mill holders available that can hold shank sizes up to 2". * Tables are cast 2" iron and precision ground. * Motor/spindle assembly tilts to positive and negative angles, cutting tool clearance angles can be adjusted as needed. * Grinding chart provides clearance angles for all end mills from 3/16"-3". Air bearing stroke - 10.5" Air bearing swing over table - 9.8". Cutting tool capacity - 2" shank, 9.8" O.D., 10.5" flute length T-Slot dimension - .800 x .500 x .670 Table feed graduations - .001 or .02mm Y-Axis table travel - 3", plus motor sildes back & forth 6" X-Axis table working space - 16.5" x 5.5" Y-Axis travel working space - 13" x 5.5" Wheel - 5" cup (or 6" dish with Z-axis), 1-1/4" arbor Motor tilt - +35/-8 degrees Motor - 1/3 hp, 3450 rpm, 110v/60hz or 220v/50hz Net weight - 180 pounds 82 kilos,br> Gross weight - 232 pounds / 106 kilos Machine dimensions, not including handles - 21" x 20" x 21" Questions email or call Bob (***)-392-5055 Certain images/photos are the copyrighted property of JupiterImages and are used with permission under license. (We do not proofread any ads submitted by members) |
crystal.caldwell@desmoines-classifieds.com (Crystal Caldwell)
for more information. Your emails will be instantly forwarded to the poster's private address.