|
Tek DA4084 Programmable Distortion Analyzer The DA4084 Programmable Distortion Analyzer is equivalent to the AA5001, a complete Distortion Analyzer System that's fully automatic! Once the mode is selected, automatic set level, automatic tuning, automatic nulling of the fundamental, and autoranging of the display all combine to permit completely hands-off operation! These automated features greatly reduce testing time and human error while providing accurate, repeatable measurements. Measurements are displayed on a 3 1/2-digit, 2000 count LED display and an analog-like bar graph that simulates an analog meter. The mainframe differs from the standard TM 5003 in that it only has a single slot(center )for the small edge card used for programmability and the first slot is empty. I assume if the center slot is used any 5000 series module should work including the double wides. Powers up and appears to work but I do not know how to test so sold with R.O.R. Even though I am familiar with most of the equipment I am not a technician and can not check this item out beyond a basic power up and/or self test if that function is available. I try to describe as accurately as possible and list as much as I know about the item. I also pop the covers when able and inspect for missing or burned components, water damage, obvious signs of attempt at repair, and anything else that is obvious to someone with a limited technical background (We do not proofread any ads submitted by members) |
May-Larson@desmoines-classifieds.com (May Larson) for more information. Your emails will be instantly forwarded to the poster's private address.
