|
WAGS stands for Water And Gas Safety valve. The WAGS valve is designed to shut off the water supply (plus gas supply for gas-fired heaters) in the event of a water leak from a hot water heater, thus minimizing water damage and possible gas leakage. The valve can be installed on all styles of water heaters. The valve is fully mechanical and requires no external power supply. Your water heater will eventually fail and leak! Most water heaters fail within 7-10 years. That’s about 5 million tank failures EVERY year. Without a WAGS valve, a leaking tank keeps refilling- and leaking. The WAGS prevents disastrous floods and untold damage to your property. The WAGS sits in a drip pan under the water heater and is activated when leaking water accumulates to a level of ¾" in the pan. Once activated the valve shuts off the water and gas supply, indicated by a red pop-up tab. General Installation Information 1. Place drip pan (see sizing chart) under the water heater before installing a WAGS valve. 2. Connect cold water supply line to "IN" port of the WAGS valve. 3. Connect "out" port of WAGS valve to the "COLD IN" of the water heater. 4. If water heater is gas fired attach included wiring harness between WAGS valve and gas valve. Additional Materials Needed for Installation: * Water heater drip pan or other suitable device that will allow the water to rise to a level of 3/4". * Two 3/4" male sweat x thread adapters. * Two lengths of copper (or other approved) tubing. Length will vary by installation – see step 9 on instruction sheet. * Two to four (depending on the installation) 90° copper (or other approved) elbows. WAGS - Water and Gas Safety Valve (We do not proofread any ads submitted by members) |
Sara_strong@desmoines-classifieds.com (Sara Strong) for more information. Your emails will be instantly forwarded to the poster's private address.