MAKE YOUR OWN Holders , for Sltting saws Endmills , Slotdrills , each Morse is case Hardened on Taper only the unfinisehed end is soft , both end's are centred, just place Morse in lathe single or Tail stock and drill hole to suit shank required , a Reamered hole is better , you can then drill & tap a grub screw into side of hole and turn Holder into a side lock holder, great for specials , or cheaper version of Collet chuck for Mill. MORSE TAPER ENDS CAN BE TAPPED TO SUIT A DRAW BAR FOR YOUR AMCHINE IF REQUIRED other sizes available list below Others available on request at C_Aguirre@desmoines-classifieds.com (We do not proofread any ads submitted by members) |
C_Aguirre@desmoines-classifieds.com (Corrine Aguirre)
for more information. Your emails will be instantly forwarded to the poster's private address.