|
Now over 1,500 items in our Store! Please note: These parts are Refurbs. DP8391A/NS32491A SNI Serial Network Interface The DP8391A Serial Network Interface (SNI) provides the Manchester data encoding and decoding functions for IEEE 802.3 Ethernet/Cheapernet type local area networks. The SNI interfaces the DP8390 Network Interface Controller (NIC) to the Ethernet transceiver cable. When transmitting, the SNI converts non-return-to-zero (NRZ) data from the controller and clock pulses into Manchester encoding and sends the converted data differentially to the transceiver. The opposite process occurs on the receive path, where a digital phase-locked loop decodes 10 Mbit/s signals with as much as The DP8391A SNI is a functionally complete Manchester encoder/decoder including ECL like balanced driver and receivers, on board crystal oscillator, collision signal translator, and a diagnostic loopback circuit. The SNI is part of a three chip set that implements the complete IEEE compatible network node electronics as shown below. The other two chips are the DP8392 Coax Transceiver Interface (CTI) and the DP8390 Network Interface Controller (NIC). Incorporated into the CTI are the transceiver, collision and jabber functions. The Media Access Protocol and the buffer management tasks are performed by the NIC. There is an isolation requirement on signal and power lines between the CTI and the SNI. This is usually accomplished by using a set of miniature pulse transformers that come in a 16-pin plastic DIP for signal lines. Power isolation, however, is done by using a DC to DC converter. Compatible with Ethernet II, IEEE 802.3; 10Base5, 10Base2, and 10Base-T 10 Mb/s Manchester encoding/decoding with receive clock recovery Patented digital phase locked loop (DPLL) decoder requires no precision external components Decodes Manchester data with up to g18 ns of jitter Loopback capability for diagnostics Externally selectable half or full step modes of operation at transmit output Squelch circuits at the receive and collision inputs reject noise High voltage protection at transceiver interface (16V) TTL/MOS compatible controller interface Connects directly to the transceiver (AUI) cable for other great component bargains on Microprocessors, Transistors, Capacitors, IC's, Transformers, Diodes, Crystals, and more! And we salute our friends in other countries around the world! (We do not proofread any ads submitted by members) |
rene.parks@desmoines-classifieds.com (Rene Parks) for more information. Your emails will be instantly forwarded to the poster's private address.
