|
Electronic Pilot Arc Controller automatically controls the pilot circuit to provide expanded metal cutting ability without having to re-trigger the torch, increasing productivity and extending tip life. * LVCâ„¢ line voltage compensation provides peak performance power under variable input voltage conditions (176-264 V) for steady cuts and cleaner ending cuts. * Fan-On-Demandâ„¢ cooling system only operates when needed, reducing the amount of airborne dust/dirt pulled through the unit. * Power factor correction (PFC) uses input power more efficiently, ultimately using less energy. * Starts without high-frequency so it will not interfere with or damage controls or computers. Internal air flow that protects electrical components and PC boards from dirt, dust, debris... greatly improving reliability. The plasma arc is created by pulling an electrical arc between an electrode and tip. This process eliminates high frequency by forcing an electrical arc between the two pieces. Protection to extend the life of consumables and the welding torch is enhanced by our post flow circuit that provides shielding gas after you release the trigge * Air Plasma Cutting and Gouging (PAC) * 15-40 A at 140 VDC, 50% duty cycle * 6 CFM (170 L/min) at 75 PSI (517 kPa) * ICE-40C hand-held torch with 25 ft (7.6 m) or 50 ft (15.2 m) cable * Heavy-duty work clamp with 25 ft(7.6 m) or 50 ft(15.2 m) cable. * 12 ft (3.7 m) industrial power cord and plug * Extra consumables (3 electrodes, 3 tips and 1 air fitting) (We do not proofread any ads submitted by members) |
M_Knowles@desmoines-classifieds.com (Mara Knowles) for more information. Your emails will be instantly forwarded to the poster's private address.
